Huawei S1700 Series - Page 87

S1700 Managed Series Ethernet Switches
Web User Manual
5 Service Management
Issue 05 (2012-10-25)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
77
Item
Description
Static Interface
Select interface for receiving this static multicast group.
Eth- Trunk List
Select Trunk for receiving this static multicast group data.
Step 3 Configure the needed parameter.
Step 4 Click Apply button to apply all the changes made.
----End
Batch Create Static Groups
Step 1 Click Service Management> IGMP Snooping> Static Groups.
Step 2 Click Batch Create button, opening the configuration page shown as the figure below.
Figure 5-43 Batch Create Static Groups
Table 5-30 Parameters of IGMP Snooping Static Groups
Item
Description
VLAN
Specify VLAN for transmitting multicast service.
Start Group Address
Batch creation of start IP address for new static multicast group.
End Group Address
Batch creation of the end IP address for new static multicast
group.
Static Interface
Select interface for receiving this static multicast group data.
Eth-Trunk List
Select Trunk for receiving this static multicast group data.
Step 3 Configure the needed parameter.
Step 4 Click Apply button to apply all the changes made.