Torch Connect Console
XPR170 Field Service Bulletin 810410 109
Replace a solenoid valve (V4-V10, V12)
Refer to Torch connect console manifold side – view 2 on page 154 for
location and part number.
1. Complete the following procedures:
a. Remove the power from the cutting system.
b. Remove the gas pressure from the cutting system.
c. Remove the top panel.
Refer to Torch connect console top panel and side panels on page 126.
Keep all nuts and screws that you remove.
2. Use the edge of the connector to disconnect the wire from the control PCB.
Be careful not to pull the wires out of the solenoid valve connector.
To Next Page
Loading...
