Hypertherm XPR170 - Replace the Air Filter Assembly

Gas Connect Consoles
2
XPR170 Field Service Bulletin 810410 79
Replace the air filter assembly

Refer to Core, VWI, and OptiMix gas connect console manifold side on
page 143 for location and part number.
1. Complete the following procedures:
a. Remove the power from the cutting system.
b. Remove the gas pressure from the cutting system.
c. Remove the top panel.

Refer to Gas connect console panels on page 100.

Keep all nuts and screws that you remove.
2. Disconnect the hoses
from the
push-to-connect fittings.
Refer to How to use
push-to-connect fittings
on page 68.
3. Use a 3 mm,
hexagonal-key wrench to
remove the 2 screws.
4. Remove the air filter
assembly.
5. Remove the 2 fittings.
6. Install the 2 fittings onto
the new air filter
assembly.
7. Use the 2 screws to
install the air filter
assembly.
8. Connect the hoses to the push-to-connect fittings. Refer to How to use push-to-connect
fittings on page 68.
9. Install the top panel.