Hypertherm XPR170 - Install the Coil Assembly

Gas Connect Consoles
2
XPR170 Field Service Bulletin 810410 75
Install the coil assembly
1. Use the screws to install the coil assembly.
2. Install the pilot arc lead connection through the insulator panel.
3. Install the set screw.
4. Twist the wire for the capacitor and the wire for pin 2 of J2.
5. Connect the following wires to the high-frequency PCB:
 The wire to J5
 The wire to pin 2 of J2
 The wire to the capacitor
6. Install the gas connect console to torch connect console coolant lead assembly.
7. Install the high-voltage-side panel.
8. Install the insulator panel.
9. Install the top panel.
10. Install the coolant. Refer to the Coolant Installation section in the XPR170 Instruction Manual
(810060).