Plasma Power Supply
XPR170 Field Service Bulletin 810410 25
6. Use a 10 mm, hexagonal-socket wrench to install the 7 nuts that attach the heat-exchanger
panel to the center panel and bottom panel.
7. Install the coolant thermistor. Refer to Replace the coolant thermistor, step 5 on page 26.
8. Connect the coolant hose fittings to the heat-exchanger assembly.
9. Remove the tape and protective material from the rear panel of the heat-exchanger assembly.
10. Add coolant to fill the tank.
11 . Install all of the panels.
To Next Page
Loading...
