Hypertherm XPR170 - Page 88

Gas Connect Consoles
2
88 810410 Field Service Bulletin XPR170
13. Do the following steps to remove the gas
regulators-bracket assembly from the manifold:
a. Use an 8 mm nut driver or wrench to remove the
2 M5 nuts that attach the bracket to the manifold.
b. Use a #2 Phillips screwdriver to remove the 2 M4
screws that attach the bracket to the manifold.
c. Remove the gas regulators-bracket assembly from
the gas connect console.
14. Do the following steps to disconnect the mixer module
from the manifold:
a. Use a 4 mm, hexagonal-key wrench to remove the
3 cap screws that attach the mixer module to the
bracket.
b. Use a 5 mm, hexagonal-key wrench to remove the
2 cap screws that attach the bracket to the
manifold.
c. Remove the mixer module from the gas connect
console.
9
9
10
10
9
10
11
12
11
11
11
12
2
12
2