Gas Connect Consoles
96 810410 Field Service Bulletin XPR170
5. Do one of the following:
Use a Phillips screwdriver to remove the 2 mounting screws from the regulator bracket.
Use an 8 mm, hexagonal-socket wrench to remove the 2 nuts from the regulator bracket.
6. Remove the regulator and bracket assembly.
7. Remove the regulator nut from the regulator that you want to replace.
8. Remove the regulator from the bracket.
9. Remove the fittings from the regulator.
Keep the fittings.
14 mm wrench
16 mm wrench
16 mm wrench
12 mm wrench
To Next Page
Loading...
