.12/ Three Voltage Converter Screws (2-H, 1-T)
.13/ Voltage Converter
(Voltage converter consists of three boards. Gently
lift voltage converter up to unplug two connectors
from system board.)
.14/ Four Diskette Drive Cables
(These cables are very fragile. Be very careful
when disconnecting them.)
Four Diskette Drive Screws (H)
.15/ Diskette Drive
.16/ Speaker
.17/ Two Battery Bracket Screws (B)
.18/ Battery Bracket
.19/ Two Hard Disk Drive Cables
(These cables are very fragile. Be very careful
when disconnecting them.)
Two Hard Disk Drive Screws (H)
.2ð/ Hard Disk Drive
(Have customer backup all information on hard disk
drive before removal. When replacing hard disk
drive, use customer's backup Reference Diskette to
restore system partition.)
.21/ Upper Left System Board Cable
Six System Board Screws (2-L, 4-H)
Lower Left System Board Cable
Upper Left System Board Cable
Upper Right System Board Cable
Two Cables, System Board Top Edge
.22/ Two Screws (T) and Keyboard Control Card
(When replacing keyboard control card, make sure
that switch setting on card is correct for type of
keyboard used.)
.23/ System Board
(Run Automatic Configuration and set time and
date.)
.24/ Two Battery Connector Card Screws (H)
.25/ Battery Connector Card
.26/ Six Keyboard Screws (H)
(Four front and two rear keyboard assembly screws.
Two rear screws are located in line with two battery
connector card screws.)
.27/ Two Speaker Bracket Screws (B)
.28/ Speaker Bracket
.29/ Keyboard Assembly
.3ð/ Three PC Board Screws (H)
.31/ Rear Panel PC Board
100 IBM Mobile Systems HMM - Volume 1