1030 Power Supply Unit
Removal
Main Cabinet Group (1010)
Remove all cables from the connectors on the riser
card. (Refer to “Riser Card” on page 455 for the
location of these connectors.)
Remove all cables from the connectors on the main
card. (Refer to “Main Card” on page 453 for the
location of these connectors.)
.1/ .2/ .3/ .4/ .5/
Lift up and turn over the power supply assembly then
release the cables on the rear of the rack .6/.
Remove all remaining cables from the connectors on
the main card.
Turn the power supply assembly to the upright
position.
.7/ .8/ .9/ (Do not forget to install the washer on the
left screw at replacement in step .9/.)
432 IBM Mobile Systems HMM - Volume 1
To Next Page
Loading...
Need help?
General