5. Press A (ENTER THE DRIVE ID FOR ERROR
LOG?), then press Enter.
6. If no errors occurred, the Log Utilities menu appears.
If errors are displayed, go to “Symptom-to-FRU Index”
on page 264.
Setup Options
The computer has two setup options that allow you to
specify how the computer operates. The System
Parameters (Ctrl+Alt+F3 from the DOS prompt or the
Diagnostic Menu) provide access to the power
management parameters and the following system
elements.
Time
Date
Password
Personalization
Diskette drive
Hard disk drive
Cache
Parallel port
ISO Monitor
Clock Multiplier
Starting Setup
Press the key combination for the setup program you want
to start.
Key Combination Setup Program
Ctrl+Alt+F3 System Parameters setup. (Must
be started at the DOS prompt or
the Diagnostic Menu.)
Func+F3 Power Management setup (can be
started at any time after the
computer is powered-on). This is
page 2 of System Parameters.
Press Esc to display the Exit Menu.
Utilities
The system is configured with several utility programs.
These programs provide added function that enhances the
usability of the system. These programs should be backed
up to prevent loss of data. Use the Diskette factory in
Microsoft Windows to make a backup copy of the
Advanced Diagnostics diskette. The utility programs are:
SIMUL Allows you to enable/disable simultaneous
display on both the LCD and external
monitor.
Note: The computer does not enter
Suspend/Resume while in the
Simultaneous mode. You must exit
Simultaneous mode before
ThinkPad 510 (2604)
273
To Next Page
Loading...
Need help?
General