EasyManuals Logo

IBM N51 Series User Manual

IBM N51 Series
503 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #437 background imageLoading...
Page #437 background image
FDD Connector: This connector is a 26-pin, D-shell
connector and is for the FDD External Attachment Kit.
Users can attach the diskette drive that was removed from
the computer to the Dock II with this kit.
Parallel Connector: The parallel connector allows
the attachment of devices that accept eight bits of parallel
data at standard transistor-transistor logic (TTL) levels.
The connector is a 25-pin, D-shell connector and is
primarily for printers. However, the connector can be used
as a general input/output connector for any device or
application that matches its input/output capabilities. The
signal from the parallel port of the computer is replicated to
the parallel connecter of
Dock II.
Serial Connector: This connector is a fully
programmable serial connector that supports asynchronous
communications. The 9-pin, D-shell connector provides
the signals to drive a serial (or EIA-232D) device. The
signal from the serial port of the computer is replicated to
the serial connecter of
Dock II.
Keyboard/Numeric Keypad Connector: This
6-pin connector on the rear of the Dock II allows the
attachment of a keyboard. The keyboard/numeric keypad
connector is marked with a small keyboard symbol. The
numeric keypad is attached to this keyboard/numeric
keypad connector.
Mouse/Pointing Device Connector: This 6-pin
connector on the rear of the Dock II allows the attachment
of a pointing device (mouse). The mouse/pointing device
connector is marked with a small mouse symbol.
Note: A mouse or pointing device will not work if either is
connected to the mouse connector of the numeric
keypad.
Riser Card
AT Slots: Two full-size AT slots (98-pin) allow the
attachment of option cards.
Storage Device Connectors: These connectors
are for the internal storage options. Any two of the
following devices are supported as storage options.
Internal hard disk drive
Internal SCSI device (1-inch height)
Internal SCSI device (half height)
Internal Hard Disk Connector:
The internal hard
disk drive connector is a 60-pin connector for the ThinkPad
hard disk or for the IDE hard disk.
Dock II (3546)
425

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM N51 Series and is the answer not in the manual?

IBM N51 Series Specifications

General IconGeneral
BrandIBM
ModelN51 Series
CategoryLaptop
LanguageEnglish

Related product manuals