.44/ Voltage Converter Cable
.45/ System Board Cable (upper left)
System Board and Mounting Bracket
(When installing system board, ensure that power
control switch on I/O panel is set to On. Also, run
Automatic Configuration and set time and date.
Transfer math coprocessor (if installed) to new
system board.)
IC DRAM Card Connector
(Connected under system board.)
.46/ Two I/O Connector Screws (LL)
.47/ I/O Connectors and Cover
.48/ Six Voltage Converter Card Screws (SS)
.49/ Two Threaded Spacers
(On voltage converter card)
Battery Cable
.5ð/ Voltage Converter Card
(Be careful to use correct screws to replace voltage
converter. Bottom cover can be cracked.)
Model CL57 (8554)
137
To Next Page
Loading...
