LCD Cable (upper-right)
.13/ LCD Display
.14/ Left Hinge Cable
.15/ Right Hinge Cable
.16/ LCD Assembly
.17/ Inverter Card
(If tape is present, remove and save tape.)
.18/ Two Rear I/O Panel Screws (GG)
(Inside rear access door at opposite ends of the
panel)
.19/ Separate Bottom Cover
(The bottom cover is held to the keyboard cover
with eight hidden latches, two on each side and four
at the front. Use a screwdriver in the slots at both
sides of the bottom cover while lifting up on
keyboard cover. Then use a screwdriver along the
front of the bottom cover.
.2ð/ Three Keyboard Cables from System Board
(upper-right)
(Release cable by pulling the slide at each side.)
.21/ Cable
(From upper-right of keyboard)
.22/ Keyboard Cover
.23/ Eight Keyboard Screws (WW)
.24/ Keyboard
.25/ Diskette Drive Cable
(Release cable by pulling the slide at each side.)
.26/ Two Diskette Drive Screws (HH)
.27/ Diskette Drive
.28/ Two Ribbon Cables
(Release cable by pulling the slide at each side.)
.29/ Hard Disk Drive
.3ð/ Three I/O Card Ribbon Cables
(Release cable by pulling the slide at each side.)
.31/ Speaker Cable
.32/ System Board
.33/ Modem Card
.34/ Speaker
(Gently pry the snaps apart to release the speaker.)
.35/ Six Threaded Hex Spacers
(From I/O Card)
.36/ One Screw (KK)
(Inside rear access door at top-center of I/O panel)
.37/ I/O Card
222 IBM Mobile Systems HMM - Volume 1
To Next Page
Loading...
Need help?
General