CAUTION:
When removing the bottom cover, be careful not
to damage the PCMCIA test card.
(Slide the bottom cover past the PCMCIA eject
button as you lift the cover off.)
(If you are not removing the hard disk drive, go to
step 9.)
.7/ Disconnect Hard Disk Drive Ribbon Cable
(Disconnect the cable from the hard disk drive.)
.8/ Remove the Hard Disk Drive
(4-G screws near FCC notice)
.9/ Lift System Board
(Gently lift the system board and turn it over. Be
careful not to lose the two plastic system board
inserts.)
.1ð/ Disconnect Pointing Device Cable
.11/ Disconnect LCD Display Cable
.12/ Disconnect Parallel Port Cable
(In metal frame on system board rear)
Power Switch Assembly, see “Parts Listing” on
page 282.
.13/ Remove Two Threaded Power Card Spacers
.14/ Remove Power Card
.15/ Remove Mouse Buttons
ThinkPad 510 (2604)
277
To Next Page
Loading...
