IBM StorVize V7000 Gen2 User Manual

6. If you are instructed to return the power supply, follow all packaging
instructions. Use any packaging materials for shipping that are supplied to you.
Replace the power supply
7. To reinstall the PSU, or replace it with one from FRU stock, follow the
procedure in “Installing or replacing a power supply: 2076-92F” on page 79.
Removing a drive: 2076-92F
You can remove a faulty drive from a 2076-92F expansion enclosure to replace it
with a new one received from FRU stock.
Before you begin
Ensure that the drive is not a spare or a member of an array. The drive status is
shown in Pools > Internal Storage in the management GUI. If the drive is a
member of an array, follow the fix procedures in the management GUI. The fix
procedures minimize the risk of losing data or access to data; the procedures also
manage the system's use of the drive.
svc01011
Figure 89. Removed power supply
102 Storwize V7000 Gen2 and Gen2+: Quick Installation Guide

IBM StorVize V7000 Gen2 Specifications

General

Category	Storage
Maximum Drives	504
RAID Levels	0, 1, 5, 6, 10
Operating System	IBM Spectrum Virtualize
Power Supply	Dual redundant power supplies
Input Voltage	100-240 V AC
Humidity	8% to 80% non-condensing
Model	Storwize V7000 Gen2
Drive Interface	SAS
Form Factor	2U
Drive Types Supported	SAS SSDs, SAS HDDs
Host Interface	8 Gb FC, 16 Gb FC, 10 Gb iSCSI
Nodes	2
Operating Temperature	10°C to 35°C
Non-operating Temperature	-10°C to 50°C