IBM StorVize V7000 Gen2 User Manual

7. Repeat steps 5 on page 47 through 6 on page 48 to install the opposite rail.
8. Install the expansion enclosure in the rack, as described in “Installing or
replacing an expansion enclosure in a rack: 2076-92F.”
Installing or replacing an expansion enclosure in a rack:
2076-92F
Use the following procedure to place the 2076-92F expansion controller in a rack
during the installation process. To complete some service tasks, you might also
need to slide the enclosure back in to the rack.
svc01022
Figure 39. Example of required rack space
Chapter 2. Installing the Storwize V7000 Gen2 and Storwize V7000 Gen2+ hardware 49

IBM StorVize V7000 Gen2 Specifications

General

Category	Storage
Maximum Drives	504
RAID Levels	0, 1, 5, 6, 10
Operating System	IBM Spectrum Virtualize
Power Supply	Dual redundant power supplies
Input Voltage	100-240 V AC
Humidity	8% to 80% non-condensing
Model	Storwize V7000 Gen2
Drive Interface	SAS
Form Factor	2U
Drive Types Supported	SAS SSDs, SAS HDDs
Host Interface	8 Gb FC, 16 Gb FC, 10 Gb iSCSI
Nodes	2
Operating Temperature	10°C to 35°C
Non-operating Temperature	-10°C to 50°C