Table 5. Steps for different installation scenarios (continued).
New system (control
enclosure only)
New system (control
enclosure and one or
more expansion
enclosures)
Adding expansion
enclosures to an
existing system
Adding control
enclosures and
expansion enclosures
to an existing system
Chapter 3,
“Configuring the
system,” on page 143
“Powering on the
system” on page 140
“Powering on the
system” on page 140
Chapter 3,
“Configuring the
system,” on page 143
“Adding a control
enclosure to an
existing system” on
page 148
1
Complete these steps for each expansion enclosure that you add.
2
Complete these steps for each control enclosure and expansion enclosure that you add.
Be familiar with the following information
v See “Caution notices for the Storwize V7000” on page x and “Danger notices for
Storwize V7000” on page xiv for a summary of the situations that can be
potentially hazardous to you. Before installing, read and understand the
following caution and danger statements.
v Use safe practices when lifting. The fully populated enclosure weighs about 37
kg (82 lbs). At least three people are required to lift and install the enclosure into
the rack or to remove an enclosure from the rack.
CAUTION:
Use safe practices when lifting.
svc00146
18-32 kg (39.7-70.5 lbs) 32-55 kg (70.5-121.2 lbs)
55 kg ( 121.2 lbs)
(27)
Also keep in mind that a rack full of equipment is extremely heavy.
DANGER: Heavy equipment–personal injury or equipment damage might
result if mishandled. (D006)
v The following general precautions should be observed, even though the
power-on steps differ slightly from the directions that you will follow for this
product:
Chapter 1. Before you begin the installation 3
To Next Page
Loading...
Need help?
General
