796 Implementing the IBM Storwize V5000 Gen2 with IBM Spectrum Virtualize V8.1
You receive a message confirming the rekey operation was successful, as shown in
Figure 13-77.
Figure 13-77 Successful key server rekey operation
13.9.2 Rekeying using USB flash drives
During the rekey process, new keys are generated and copied to the USB flash drives. These
keys are then used instead of the current keys. The rekey operation fails if at least one of the
USB flash drives does not contain the current key. To rekey the system, you need at least
three USB flash drives to store the master access key copies.
After the rekey operation is complete, update all other copies of the encryption key, including
copies stored on other media. Take the same precautions to securely store all copies of the
new encryption key as when you were enabling encryption for the first time.
To rekey the master access key located on USB flash drives provider, complete these steps:
1. Click Settings → Security → Encryption. Click the USB Flash Drives section label to
expand the section as shown in Figure 13-78.
Figure 13-78 Locate USB Flash Drive section in the Encryption view
To Next Page
Loading...
Need help?
General