Chapter 6. Volume configuration 317
4. Next, in the General sub-section enter the caching mode as Enabled, Read-only or
Disabled as shown in Figure 6-28. Also enter unit device identifier (UDID) if this volume is
going to be mapped to an OpenVMS host.
Figure 6-28 General details
5. Click Create to define the volume as shown in Figure 6-29.
Figure 6-29 Task completed, the thin-provisioned volume is created
6.5.2 Creating Custom Compressed volumes
The configuration of compressed volumes is similar to thin-provisioned volumes. To create a
Compressed volume, complete the following steps:
1. From the Create Volumes window, select the Custom option. In the Volume Location
subsection define the pool in which the volume is created.Use the drop-down menu in the
Pool option to choose the pool.
To Next Page
Loading...
Need help?
General