Table 9. DSA Preboot messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved.
v If an action step is preceded by “(Trained technician only),” that step must be performed only by a trained technician.
v Go to the IBM support website at http://www.ibm.com/supportportal/ to check for technical information, hints, tips, and
new device drivers or to submit a request for information.
Message
number Component Test State Description Action
202-802-xxx Memory Memory
Stress Test
Failed General
error:
memory
size is
insufficient
to run the
test.
1. Make sure that all memory is enabled by checking the
Available System Memory in the Resource Utilization
section of the DSA event log. If necessary, enable all
memory in the Setup utility (see “Using the Setup utility”
on page 301).
2. Make sure that the DSA code is at the latest level. For
the latest level of DSA code, go to http://www.ibm.com/
support/docview.wss?uid=psg1SERV-DSA.
3. Run the test again.
4. Run the standard memory test to validate all memory.
5. If the failure remains, go to the IBM website for more
troubleshooting information at http://www.ibm.com/
systems/support/supportsite.wss/
docdisplay?brandind=5000008&lndocid=SERV-CALL.
202-901-xxx Memory Memory
Stress Test
Failed Test
failure.
1. Run the standard memory test to validate all memory.
2. Make sure that the DSA code is at the latest level. For
the latest level of DSA code, go to http://www.ibm.com/
support/docview.wss?uid=psg1SERV-DSA.
3. Turn off the system and disconnect it from power.
4. Reseat the DIMMs.
5. Reconnect the system to power and turn on the system.
6. Run the test again.
7. Run the standard memory test to validate all memory.
8. If the failure remains, go to the IBM website for more
troubleshooting information at http://www.ibm.com/
systems/support/supportsite.wss/
docdisplay?brandind=5000008&lndocid=SERV-CALL.
164 IBM System x3650 M4 Type 7915: Problem Determination and Service Guide
To Next Page
Loading...
