1. Read the safety information that begins on page vii and “Installation guidelines”
on page 191.
2. Turn off the server and peripheral devices and disconnect all power cords and
external devices.
3. Remove the cover (see “Removing the cover” on page 205).
4. Connect one end of the battery cable to the ServeRAID adapter battery
connector.
5. Route the remote battery cable along the chassis.
Attention: Make sure that the cable is not pinched and does not cover any
connectors or obstruct any components on the system board.
6. Install the battery near the fan cage:
a. Align the battery cable connector with the slot on the battery holder. Place
the battery into the battery holder and make sure that the battery holder
engages the battery securely.
Chapter 5. Removing and replacing server components 233
To Next Page
Loading...
