Battery
Battery cable
connector
Note: The positioning of the remote battery depends on the type of remote
battery that you install.
b. Connect the other end of the battery cable to the battery cable connector on
the battery.
TMMB board
Battery
Battery cable
Note: Make sure the battery is seated properly (see “Installing a ServeRAID
SAS controller battery on the remote battery tray” on page 232).
c. Place the battery retention clip underneath while pressing the release tab
toward the front of the server until it snaps in place to hold the battery
retention clip firmly in place.
234 IBM System x3650 M4 Type 7915: Problem Determination and Service Guide
To Next Page
Loading...
