v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v If an action step is preceded by “(Trained technician only),” that step must be performed only by a trained
technician.
v Go to the IBM support website at http://www.ibm.com/supportportal/ to check for technical information,
hints, tips, and new device drivers or to submit a request for information.
Diagnostic
code Message Description Action
S.30050007 [S.3050007] A firmware
fault has been detected
in the UEFI image.
Internal UEFI Firmware
Fault Detected, System
halted.
1. Check the IBM support website for an
applicable retain tip or firmware update that
applies to this error.
2. Recover the server firmware (see
“Recovering the server firmware” on page
171).
W.305000A [W.305000A] An invalid
date and time have
been detected.
RTC Date and Time
Incorrect.
1. Run the Setup utility (see “Using the Setup
utility” on page 301). Select Load Default
Settings, and save the settings.
2. Reseat the battery (see “Removing the
battery” on page 273 and “Installing the
battery” on page 275).
3. Replace the battery.
S.3058004 [S.3058004] A Three
Strike boot failure has
occurred. The system
has booted with default
UEFI settings.
POST failure has
occurred! System
booted with default
settings..
1. Undo any recent system changes, such as
new settings or newly installed devices.
2. Make sure that the server is attached to a
reliable power source.
3. Remove all hardware that is not listed on the
ServerProven web site at
http://www.ibm.com/systems/info/x86servers/
serverproven/compat/us/.
4. Update the firmware to the latest level (see
“Updating the firmware” on page 297 for more
information).
5. Make sure that the operating system is not
corrupted.
6. Run the Setup utility, save the configuration,
and then restart the server.
7. (Trained technician only) If the problem
remains, replace the system board (see
“Removing the system board” on page 290
and “Installing the system board” on page
292).
W.3058009 [W.3058009] DRIVER
HEALTH PROTOCOL:
Missing Configuraiton.
Requires Change
Settings From F1.
DRIVER HEALTH
PROTOCOL: Missing
Configuration. Requires
Change Settings From
F1.
1. Select System Settings → Settings → Driver
Health Status List and find a driver/controller
reporting configuration required status.
2. Search for the driver menu from System
Settings and change the settings
appropriately.
3. Save the settings and restart the system.
Chapter 3. Diagnostics 43
To Next Page
Loading...
