Icom IC-7600

■ Programming a memory name
103
5
VOICE RECORDER FUNCTIONS
F-1 F-2 F-4F-3
DEL
SPACE
F-5 F-6
EXIT/SET
Main dial
Symbol ABC
123 abc
T1..T4
Keypad
NAME
• Voice mic. record screen
Voice memory name editing example
Memory messages can be tagged with alphanumeric
names of up to 30 characters each.
Capital letters, small letters, numerals, some symbols
(! # $ % & ¥ ? " ’ ` ^ + – ✱ / . , : ; = < > ( ) [ ] { } ¦ _
–
@)
and spaces can be used. (See the table below.)
q Record a message as described in page 102.
w During the voice mic. record screen display,
push [NAME] (F-5) to enter memory name edit
condition.
• A cursor appears and blinks.
e Push [T1..T4] (F-6) several times to select the
desired voice message.
r Input the desired character by rotating the main
dial or by pushing the band key for number input.
• Push [ABC] (MF6) or [abc] (MF6) to toggle capital and
small letters.
• Push [123] (MF7) or [Symbol] (MF7) to toggle
numerals and symbols.
• Push [Ω] (F-1) or [≈] (F-2) for cursor movement.
• Push [DEL] (F-3) to delete the selected character.
• Push [SPACE] (F-4) to input a space.
• Pushing the transceiver’s keypad, [0]–[9] and [.] can
also enter numerals.
t Push [EXIT/SET] to input and set the name.
• The cursor disappears.
y Repeat steps e to t to program another voice
message’s name, if desired.
u Push [EXIT/SET] twice to exit the voice recorder
screen.
• Usable characters
Key selection Editable characters
A to Z (capital letters)
a to z (small letters)
0 to 9 (numbers)
! # $ % & ¥ ? “ ‘ ` ^ + – ✱ /
. , : ; = < > ( ) [ ] { } ¦ _
–
@
For your convenience ✓
When a PC keyboard is connected to [USB] (A)
connector on the front panel, the memory name can
also be edited from the keyboard.