■ Rear panel
12ANT
DC 13.8V
X-VERTER
RX-ANT
ACC
TUNER
IN OUT ALC SEND
KEY
12
METER
REMOTE
EXT
-
SP
qw re
tyo!0!1!2!7 !6 !5 !4 !3 iu
q GROUND TERMINAL [GND] (p. 16)
Connect this terminal to a ground to prevent
electrical shocks, TVI, BCI and other problems.
w ANTENNA CONNECTOR 1 [ANT1]
e ANTENNA CONNECTOR 2 [ANT2] (pp. 17, 120)
Accepts a 50 ø antenna with a PL-259 plug
connector.
When using an optional AH-4 h f /50 MHz
a u t o m a t i c a n t e n n a t u n e r , connect it to the
[ANT1] connector. The internal antenna tuner
activates for [ANT2] and deactivates for [ANT1]
when connecting the AH-4.
r DC POWER SOCKET [DC 13.8V] (p. 20)
Accepts 13.8 V DC through the supplied DC power
cable.
t EXTERNAL SPEAKER JACK [EXT-SP] (p. 18)
Connects to an external speaker (4–8 ø), if
desired.
y CI-V REMOTE CONTROL JACK [REMOTE]
(pp. 18, 159)
➥ Connects to a PC, using the optional CT-17 c i -v
l e v e l c o n v e r t e r , for external control of the
transceiver.
➥ Used for transceive operation with another Icom
CI-V transceiver or receiver.
u USB (Universal Serial Bus) CONNECTOR
(B type) [USB] (B)
Connects to a PC, using a USB cable, to do the
following:
- Input the modulation (p. 132)
- Remotely control the transceiver using CI-V
commands (p. 159)
- Send the received audio to the PC (p. 132)
- Send the decoded characters to the PC
(pp. 141, 142)
CAUTION:
NEVER connect the USB cable between the
transceiver and the PC until AFTER the USB
driver has been installed.
About the USB driver:
The USB driver and the installation guide can be
downloaded from our website.
http://www.icom.co.jp/world/index.html
The following items are required:
PC
• Microsoft
®
Windows
®
8/8.1 (32/64 bit)*,
Microsoft
®
Windows
®
7 (32/64 bit), or
Microsoft
®
Windows Vista
®
(32/64 bit) OS
*Except for Microsoft
®
Windows
®
RT.
• A USB 1.1, 2.0 or 3.0 port
Other items
• USB cable (user supplied)
• PC software
About the modulation input:
Select “USB” in the ACC set mode item ‘DATA OFF
MOD,’ ‘DATA1 MOD,’ ‘DATA2 MOD’ or ‘DATA3 MOD.’
And the modulation input level from USB jack can
be set in the ACC set mode item ‘USB MOD Level.’
(p. 132)
11
1
PANEL DESCRIPTION
To Next Page
Loading...
