Icom IC-7600

■ Tone scan
The transceiver can detect subaudible tones in a
received signal. By monitoring a signal that is being
transmitted on a repeater input frequency, you can
determine the tone frequency required to access the
repeater.
q Set the desired frequency or memory channel to
be checked for a tone frequency.
w Push [AM/FM] several times to select the FM
mode.
e Hold down [TONE] (MF7) for 1 second to select
the tone frequency screen.
r Push [Y] (F-1) or [Z] (F-2) to check the repeater
tone frequency or tone squelch frequency,
respectively.
t Push [T-SCAN] (F-6) to start the tone scan.
• “SCAN” blinks while scanning.
y When a matching tone frequency is detected, the
tone scan pauses.
• The tone frequency is set temporarily on a memory
channel. Program the memory channel to store the
tone frequency permanently.
• The decoded tone frequency is used for the repeater
tone frequency or tone squelch frequency.
u To stop the scan, push [T-SCAN] (F-6).
• Hold down [DEF] (F-4) for 1 second to select the
default frequency.
i Push [EXIT/SET] to exit tone frequency screen.
119
7
SCANS
F-1 F-2
EXIT/SET
AM/FM
TONE
T- SCAN
DEF
F-4
F-6