Icom IC-7600

47
4
RECEIVE AND TRANSMIT
D Contest number set mode
This menu is used to set the contest (serial) number
and count-up trigger, etc.
• Setting contents
q During the CW mode operation, push [KEYER]
(F-3) to select memory keyer screen.
w Push [EXIT/SET] to select memory keyer menu,
then push [001] (F-3) to select the contest serial
number set mode.
e Push [Y] (F-1) or [Z] (F-2) to select the desired
set item.
r Set the desired condition using the main dial.
• Hold down [DEF] (F-4) for 1 second to select the
default condition or value.
t Push [EXIT/SET] twice to return to the normal
screen.
Number Style Normal
This item sets the numbering system used for
contest (serial) numbers— normal or short morse
numbers.
Short morse numbers are also referred to as “cut”
numbers.
• Normal : Does not use short morse numbers
(default)
• 190➔ANO : Sets 1 as A, 9 as N and 0 as O.
• 190➔ANT : Sets 1 as A, 9 as N and 0 as T.
• 90➔ NO : Sets 9 as N and 0 as O.
• 90➔ NT : Sets 9 as N and 0 as T.
Count Up Trigger M2
The count-up trigger allows the contest serial
number to automatically increment after each
complete serial number exchange is sent.
• M1, M2, M3 and M4 can be set. (default: M2)
Present Number 001
This item shows the current number for the count-up
trigger channel set above.
• Rotate the main dial to change the number, or hold
down [001CLR] (F-4) for 1 second to reset the
current number to 001.
• Contest number set mode screen
Main dial
F-1 F-2
F-4
EXIT/SET
F-3
KEYER 001
/
001CLR
/
DEF