Icom IC-7600

■ Memory scan operation
q Push [EXIT/SET] several times to close any multi-
function screens, if necessary.
w Select memory mode.
e Push [SCAN] (F-5) to select the scan screen.
r Set [RF/SQL] open or closed.
• See page 113 for squelch condition.
• If the [RF/SQL] control function is set as “AUTO,” the
squelch is always open in the SSB, CW, RTTY and
PSK modes. (pp. 2, 37, 136)
t Push [MEMO] (F-1) to start the memory scan.
• “ ” and decimal points blink while
scanning.
y When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume
setting and the squelch condition.
u To cancel the scan, push [MEMO] (F-1).
• Rotating the main dial also cancels the scan.
2 or more memory channels must be programmed
for a memory scan to start.
117
7
SCANS
F-1 F-5
EXIT/SET
Main dial
[RF/SQL]
SCANMEMO
F-3
SELECT
F-1
F-4 F-5
EXIT/SET
Main dial
[RF/SQL]
SCAN
MEMO
SEL No.
q Push [EXIT/SET] several times to close any multi-
function screens, if necessary.
w Select memory mode.
e Push [SCAN] (F-5) to select the scan screen.
r Set [RF/SQL] open or closed.
• See page 113 for squelch condition.
• If the [RF/SQL] control function is set as “AUTO,” the
squelch is always open in the SSB, CW, RTTY and
PSK modes. (pp. 2, 37, 136)
t Push [MEMO] (F-1) to start the memory scan.
• “ ” and decimal points blink while
scanning.
y Push [SEL No.] (F-4) several times to select the
select scan number from ★ 1, ★ 2, ★ 3 and ★ 1,2,3.
u Push [SELECT] (F-3) to start select memory scan,
push [SELECT] (F-3) again to return to memory
scan, if desired.
• “ ” blinks instead of
“
” during a select memory scan.
i When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume
setting and the squelch condition.
o To cancel the scan, push [MEMO] (F-1).
• Rotating the main dial also cancels the scan.
2 or more memory channels must be designated
as select memory channels, as well as the same
select scan channel number, for select memory
scan to start.
■ Select memory scan operation