Icom IC-7600

■ Frequency transfers
The frequency and operating mode in a memory
channel can be transferred to the VFO in either VFO
mode or memory mode.
D Transferring in the VFO mode
This is useful for transferring programmed contents to
a VFO.
q Select the VFO mode by pushing [VFO/MEMO].
w Select the memory channel to be transferred with
[∫]/[√].
• The Memory list screen is convenient for selecting the
desired channel.
• Memory channel contents appear in the memory
channel readout (below the frequency readout).
• “--.---.--” appears if the selected memory channel is a
blank channel. In this case transferring is not possible.
e Hold down [VFO/MEMO] for 1 second to transfer
the frequency and operating mode.
• Transferred frequency and operating mode appear on
the frequency readout.
D
Transferring in the memory mode
This is useful for transferring the frequency and
operating mode while operating in the memory mode.
When you have changed the frequency or
operating mode in the selected memory channel:
• Displayed frequency, mode and filter setting are
transferred.
• Programmed frequency, mode and filter in the
memory channel are not transferred, and they
remain in the memory channel.
q Select the memory channel to be transferred with
[∫]/[√] in memory mode.
• Then, set the frequency or operating mode if required.
w Hold down [VFO/MEMO] for 1 second to transfer
the frequency, mode and filter.
• Displayed frequency, mode and lter are transferred to
the VFO.
e To return to VFO mode, push [VFO/MEMO]
momentarily.
110
6
MEMORY OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
TRANSFER EXAMPLE IN VFO MODE
Operating frequency : 21.320 MHz/USB (VFO)
Contents of M-ch 16 : 14.018 MHz/CW
Push for 1 sec.
Beep
Beep
Beep
or
VFO/MEMO
TRANSFER EXAMPLE IN MEMORY MODE
VFO frequency : 21.320 MHz/USB
Contents of M-ch 16 : 14.018 MHz/CW
Push for 1 sec.
Beep
Beep
Beep
Programmed contents appear.
VFO/MEMO