Icom IC-7600

■ Firmware update
The transceiver displays its firmware version
information after turning power ON, if the opening
message screen indication capability is ON. (p. 135)
q Copy the downloaded firmware data into the “IC-
7600” folder of the USB-Memory.
• The USB-Memory must have been formatted by the
IC-7600.
w Insert the USB-Memory into the [USB] (A)
connector on the front panel.
e Push [EXIT/SET] several times to close any multi-
function screens, if necessary.
r Push [SET] (F-6) to select the set mode menu
screen.
t Push [USB] (F-6) to select the USB Memory set
menu.
y Hold down [FIRM UP] (F-3) for 1 second.
u Read the displayed precaution carefully.
• Push [Y] (F-1) or [Z] (F-2) to scroll the display.
• Push [CANCEL] (F-6)
to cancel the firmware updating.
i After you read and understand all of the
precautions, push [OK] (F-5).
• [OK] (F-5) appears only following the precautions.
• Push [CANCEL] (F-6)
to cancel the firmware updating.
o Push [Y] (F-2) or [Z] (F-3) to select the firmware
file, then push [FIRM UP] (F-4).
!0 Read the displayed precautions carefully.
!1 If you agree, hold down [OK] (F-5) for 1 second to
start the firmware update.
• Push [CANCEL] (F-6) to cancel the firmware updating.
!2 While loading the firmware from the USB-Memory,
the dialog to the right is displayed.
175
14
UPDATING THE FIRMWARE
F-1 F-2
F-5 F-6
EXIT/SET
USBSET CANCEL
DIR/FILE
OK
F-4
FIRM UP
F-3
FIRM UP
[USB] (A)
//
//
/