Icom IC-7600

■ Level set mode
SSB RX HPF/LPF – – – – – – –
Sets the high-pass filter (100 to 2000 Hz) and low-
pass filter (500 to 2400 Hz) of the receive audio in
100 Hz steps in the SSB mode. (default: OFF)
NOTE: When this setting is active, below 2 items
will be reset to default value, ‘0.’
SSB RX Tone (Bass) 0
Sets the bass level of the receive audio tone in the
SSB mode from –5 to +5. (default: 0)
SSB RX Tone (Treble) 0
Sets the treble level of the receive audio tone in the
SSB mode from –5 to +5. (default: 0)
AM RX HPF/LPF – – – – – – –
Sets the high-pass filter (100 to 2000 Hz) and low-
pass filter (500 to 2400 Hz) of the receive audio in
100 Hz steps in the AM mode. (default: OFF)
NOTE: When this setting is active, below 2 items
will be reset to default value, ‘0.’
AM RX Tone (Bass) 0
Sets the bass level of the receive audio tone in the
AM mode from –5 to +5. (default: 0)
AM RX Tone (Treble) 0
Sets the treble level of the receive audio tone in the
AM mode from –5 to +5. (default: 0)
FM RX HPF/LPF – – – – – – –
Sets the high-pass filter (100 to 2000 Hz) and low-
pass filter (500 to 2400 Hz) of the receive audio in
100 Hz steps in the FM mode. (default: OFF)
NOTE: When this setting is active, below 2 items
will be reset to default value, ‘0.’
FM RX Tone (Bass) 0
Sets the bass level of the receive audio tone in the
FM mode from –5 to +5. (default: 0)
FM RX Tone (Treble) 0
Sets the treble level of the receive audio tone in the
FM mode from –5 to +5. (default: 0)
128
10
SET MODE
10
Continued on the next page. ☞