Icom IC-7600

q, w Memory channel number
0000–0099 : Memory channel 0 to 99
0100 : Programmed scan edge P1
0101 : Programmed scan edge P2
e Select memory setting
00 : OFF
01 : 1
02 : 2
03 : 3
To program the blank channel, enter “FF” to e after
the memory channel number (q and w).
This completes the memory channel programming.
q
XX XXXX
we
r–i Operating frequency setting
See “• Operating frequency.”
o, !0 Operating mode setting
See “• Operating mode.”
!1 Data mode setting
1 byte data (XX)
XX
!1
0: OFF, 1: TONE, 2: TSQL
0: OFF, 1: DATA 1, 2: DATA 2, 3: DATA 3
!2–!4 Repeater tone frequency setting
!5–!7 Tone squelch frequency setting
See “• Repeater tone/tone squelch setting.”
!8–@7 Memory name setting
Up to 10 characters.
See “• Codes for memory name, opening message
and Clock 2 name contents.”
169
12
CONTROL COMMAND
Data content description (continued) D
• Memory content setting
Command: 1A 00
X
er−io, !0 !1 !2−!4 !5−!7
XXX ... ...XXXXXXXXXXXXXXXXXXXXXX XXXX XX
q, w!8−@7