Icom IC-7600

Rear panel— 2 D
12ANT
DC 13.8V
X-VERTER
RX-ANT
ACC
TUNER
IN OUT ALC SEND
KEY
12
METER
REMOTE
EXT
- SP
[METER]
Connect an external meter, etc.
3.5 (d) mm, 1⁄8" plug
Output impedance : 4.7 kø
Output voltage (open circuit) : 2.5 V (default)
Output voltage can be adjusted 0 to 5 V
in ACC set mode. (p. 133)
[USB] (B)
When the transceiver is connected
to a PC, a USB cable (user supplied)
should be connected to the USB
connector (B type) on the rear panel.
(p. 11)
■ USB connection
Connect the USB-Memory* to the USB connector
(A type) on the front panel.
• Unmount operation is recommended before removing the
USB-Memory*. (p.150)
Be sure to connect the USB-Memory correctly.
NEVER connect or remove the USB-Memory when
the read/write indicator is lit or blinks.
A USB keyboard* or a USB hub* can also be con-
nected to the USB connector.
* USB-Memory, USB keyboard and USB hub are not sup-
plied by Icom.
or
19
2
INSTALLATION AND CONNECTIONS