Icom IC-7600

148
10
SET MODE
10
D Save option set mode
SAVE Contents All
Selects the file save option from All or Select.
(default: All)
• All : Saves all the following contents.
• Select : Saves the selected contents only.
Memory & Settings YES
This setting is fixed “YES.” • YES : Saves memory channel contents and
settings of set modes.
Voice TX Memory YES
Selects the voice TX message save option YES or
NO. (default: YES)
• YES : Saves the voice TX message.
• NO : Does not save.
Voice RX Memory NO
Selects the voice RX message save option YES or
NO. (default: NO)
• YES : Saves the voice RX message.
• NO : Does not save.
SAVE Form Now Ver
Selects the file saving format between “Now Ver”
and “Old Ver.” (default: Now Ver)
To save settings and memory contents for backup
or copying to another IC-7600, you must save the
data in the firmware version format that matches the
target IC-7600.
Select “Now Ver” for the current version, or “Old Ver
(xxx - xxx)” for the previous version.
• The previous versions are shown in brackets, and you
can select the desired version by rotating the main dial.
The file will be saved in the selected version.
See page 173 for confirming the firmware version of the
IC-7600.
• Now Ver : Saves the le in the current rmware
version format.
• Old Ver : Saves the le in the rmware version
format shown in brackets.
NOTE:
• You cannot write setting le that is saved in the
current version format to an older firmware
version IC-7600.
• If the settings are saved in an older version
format, the items added in version 2.00 or later
are not saved.