TX Delay (50M) OFF
If the transceiver transmits power before an external
device, such as a linear amplifier, is ready to
operate, the transmitted power will be reflected back
and can damage the transceiver. Therefore a time
delay can be set to delay the transceiver output until
the external device is ready.
Set the TX delay time on the 50 MHz band to 10,
15, 20, 25, or 30 milliseconds, or select “OFF” for no
delay time, depending on the needs of your external
device. (default: OFF)
Time-Out Timer (CI-V) OFF
If a continuous transmission exceeds the
selected time period, this function will cut off the
transmission, to prevent a prolonged transmission.
Set the Time-Out Timer function to ON, and select
a time of 3, 5, 10, 20 or 30 minutes, or turn the
function OFF. (default: OFF)
NOTE: This function will be activated only when
you transmit using CI-V commands, or pushing
[TRANSMIT] on the transceiver.
Quick Dualwatch ON
When this item is set to ON, holding down
[DUALWATCH] for 1 second sets the sub readout
frequency to the main readout frequency, and
activates dualwatch operation.
• OFF : Quick dualwatch OFF
• ON : Quick dualwatch ON (default)
Quick SPLIT ON
When this item is set to ON, holding down [SPLIT]
for 1 second sets the unselected VFO’s readout
frequency and operating mode to the selected
VFO’s readout, and activates split operation.
(default: ON)
See page 97 for details.
• OFF : Quick split OFF
• ON : Quick split ON
FM SPLIT Offset (HF) –0.100MHz
Sets the offset (difference between transmit and
receive frequencies) for the quick split function. This
setting is used for HF bands in the FM mode only and
is used to input the repeater offset for an HF band.
The offset frequency can be set from –9.999 to
+9.999 MHz in 1 kHz steps. (default: –0.100 MHz)
FM SPLIT Offset (50M) –0.500MHz
Sets the offset (difference between transmit and
receive frequencies) for the quick split function. This
setting is used for 50 MHz band FM mode only, and is
used to input the repeater offset for the 50 MHz band.
The offset frequency can be set from –9.999 to
+9.999 MHz in 1 kHz steps. (default: –0.500 MHz)
SPLIT LOCK OFF
When this item is ON, the main dial can be used to
adjust the transmit frequency while pushing [XFC],
even while the lock function is activated.
(default: OFF)
• OFF : Split lock OFF
• ON : Split lock ON
See pages 96 and 97 for split frequency operation
details.
137
10
SET MODE
Others set mode (Continued) ■
To Next Page
Loading...
