Icom IC-7600

6
107
MEMORY OPERATION
MEMORY
CHANNEL
MEMORY
CHANNEL
NUMBER
CAPABILITY
TRANSFER
TO VFO
OVER-WRIT-
ING
CLEAR
Regular memory
channels
1–99
One frequency and one mode in each
memory channel.
Yes Yes Yes
Scan edge
memory
channels
P1, P2
One frequency and one mode in each
memory channel as scan edges for
programmed scan.
Yes Yes No
VFO/MEMO
VFO/MEMO
Keypad
F-INP
ENT
D Using the [∫]/[√] keys
q Push [VFO/MEMO] to select the memory mode.
w Push [∫]/[√] several times to select the desired
memory channel.
• Hold down [∫]/[√] for continuous scrolling.
• [UP] and [DN] on the microphone can also be used.
e To return to VFO mode, push [VFO/MEMO] again.
D Using the keypad
q Push [VFO/MEMO] to select the memory mode.
w Push [F-INP ENT].
e Enter the desired memory channel number using
the keypad.
• Enter 100 or 101 to select scan edge channel P1 or
P2, respectively.
r Push [∫] or [√] to set the memory channel.
[EXAMPLE]
To select memory channel 3:
Push ➥ [F-INP ENT], [7 3], then push [∫] or [√].
To select memory channel 12:
Push ➥ [F-INP ENT], [1.8 1], [3.5 2], then push [∫]
or [√].
To select the scan edge channel P1:
Push ➥ [F-INP ENT], [1.8 1], [50 0], [50 0], then
push [∫] or [√].
To select the scan edge channel P2:
Push ➥ [F-INP ENT], [1.8 1], [50 0], [1.8 1], then
push [∫] or [√].
■ Memory channel selection
The transceiver has 101 memory channels. The
Memory mode is very useful to quickly change to
often-used frequencies.
All 101 memory channels are tunable, which means
the programmed frequency can be tuned temporarily
with the main dial, etc. in memory mode.
■ Memory channels