Icom IC-7600

Memopad Numbers 5
Sets the number of memo pad channels available.
5 or 10 memo pads can be selected. (default: 5)
MAIN DIAL Auto TS HIGH
Sets the auto tuning step function for the main dial.
When rapidly rotating the main dial, the tuning step
automatically changes several times as selected.
There are 2 type of auto tuning steps: HIGH
(Fastest) and LOW (Faster). (default: HIGH)
• HIGH : Approximately 5 times faster when the
tuning step is set to 1 kHz or smaller steps,
approximately 2 times faster when the
tuning step is set to 5 kHz or larger steps.
• LOW : Approximately 2 times faster
• OFF : Auto tuning step is turned OFF.
MIC Up/Down Speed HIGH
Sets the rate at which frequencies are scanned
when the microphone [UP]/[DN] switches are held
down. HIGH or LOW can be selected.
• LOW : Low speed (25 tuning steps/second)
• HIGH : High speed ( 50 tuning steps/second
: default)
Quick RIT/∂TX Clear OFF
Selects the RIT/∂TX frequency clearing instruction
with [CLEAR]. (default: OFF)
• OFF : Clears the RIT/∂TX frequency when
[CLEAR] is held down for 1 second.
• ON : Clears the RIT/∂TX frequency when
[CLEAR] is pushed momentarily.
[NOTCH] Switch (SSB) Auto/Manual
Selects notch functions for the SSB mode operation
from Auto, Manual and Auto/Manual.
(default: Auto/Manual)
• Auto : Only the auto notch can be used.
• Manual : Only the manual notch can be used.
• Auto/Manual : Both the auto and manual notch can
be used. (default)
[NOTCH] Switch (AM) Auto/Manual
Selects notch functions for the AM mode operation
from Auto, Manual and Auto/Manual.
(default: Auto/Manual)
• Auto : Only the auto notch can be used.
• Manual : Only the manual notch can be used.
• Auto/Manual : Both the auto and manual notch can
be used.
SSB/CW Synchronous Tuning OFF
Selects the displayed frequency shift function from
ON and OFF. (default: OFF)
When this function is activated, the audio pitch or
tones of the received signal will remain the same
even when the operating mode is changed between
SSB and CW.
The amount of frequency shift may differ
according to the CW pitch setting.
• OFF : The displayed frequency does not shift.
• ON : The displayed frequency shifts when the
operating mode is changed between SSB
and CW.
CW Normal Side LSB
Selects the sideband used to receive CW in the CW
normal mode from LSB and USB. (default: LSB)
140
10
SET MODE
10