Icom IC-7600

Level set mode (Continued) ■
APF AF Level 0 dB
Sets the audio level for the audio peak filter in the
CW mode from 0 to +6 dB in 1 dB steps.
Beep Level 50
%
Sets the beep output level from 0% to 100% in 1%
steps. (default: 50%)
Beep Level Limit ON
Turns the beep tone output level limiting capability
ON or OFF for the confirmation and band edge beep
tones. (default: ON)
When this item is set to ON, the beep tones are
linked to the [AF] control until rotation of the [AF]
control reaches to the specified level—further
rotation will not increase the volume of the beep
tones.
• OFF : Beep level is linked to the [AF] control.
• ON : Beep level is limited with the [AF] control.
131
10
SET MODE