Icom IC-7600

54
4
RECEIVE AND TRANSMIT
4
D Editing RTTY memory
The contents of the RTTY memories can be set
using the memory edit menu. The memory can store
and re-transmit 8 RTTY message for often-used
RTTY information. Total capacity of the memory is 70
characters per memory channel.
• Programming contents
q During the RTTY mode operation, push [DECODE]
(F-3) to select the RTTY decode screen.
w Push [TX MEM] (F-3) to select the RTTY memory
screen, then push [EDIT] (F-5) to select the RTTY
memory edit screen.
• RTTY memory contents of Channel 1 (RT1) is selected.
e Push [RT1..RT8] (F-6) several times to select the
desired RTTY memory channel to be edited.
r Push [ABC] (MF6) or [123]/[Symbol] (MF7) to
select the character group, then rotate the main
dial to select the character, or push the keypad for
number input.
• [Symbol] (MF7) appears when [123] (MF7) is pushed
when “123” character group is selected.
• Selectable characters (using the main dial):
Key selection Characters
A to Z (capital letters)
0 to 9 (numbers)
! $ & ? " ’ – / . , : ; ( ) ↵
t Push [Ω] (F-1) or [≈] (F-2) to move the cursor
backwards or forwards, respectively.
• Pushing [DEL] (F-3) deletes a character and [SPACE]
(F-4)
inserts a space.
y Repeat steps r and t to input the desired
characters.
u Push [EXIT/SET] to set the contents and exit the
RTTY memory edit screen.
For your convenience ✓
When a PC keyboard is connected to the [USB]
connector on the front panel, the RTTY memory
contents can also be edited from the keyboard.
EXIT/SET
F-3 F-6
F-5
/
DECODE TX MEM
EDIT
RT1..RT8
F-1 F-2 F-4
Main dial
Symbol ABC
123
F-3
DEL
SPACE
Keypad
• RTTY memory edit screen
• Pre-programmed contents
CH Contents
RT1
↵DE ICOM ICOM K↵
RT2
↵DE ICOM ICOM ICOM K↵
RT3
↵QSL UR 599–599 BK↵
RT4
↵QSL DE ICOM ICOM UR 599–599 BK↵
RT5
↵73 GL SK↵
RT6
↵CQ CQ CQ DE ICOM ICOM ICOM K↵
RT7
↵MY TRANSCEIVER IS IC–7600 & ANTENNA
IS A 3–ELEMENT TRIBAND YAGI.↵
RT8
↵MY RTTY EQUIPMENT IS INTERNAL FSK
UNIT & DEMODULATOR OF THE IC–7600.↵