Icom IC-7600

25
2
INSTALLATION AND CONNECTIONS
Microphones (Continued) ■
D SM-50
D SM-30
q
r
w
e
q
w
t
MIC GAIN
ONOFF
LOW CUT
yr
MIC GAIN
y
TOP VIEW
TOP VIEW
BOTTOM VIEW
BOTTOM VIEW
q PTT SWITCH
Hold down to transmit, release to receive.
w PTT LOCK SWITCH
Push to lock the PTT switch in the transmit mode.
e UP/DOWN SWITCHES [UP]/[DN]
Change the selected readout frequency or memory
channel.
• Holding down continuously changes the frequency or
memory channel.
• While holding down [XFC], the transmit readout
frequency can be controlled while in the split frequency
mode.
• The [UP]/[DN] switch can simulate a key paddle. Preset
in the keyer set mode. (p. 49)
r LOW CUT SWITCH
Push (SM-50)/Slide (SM-30) to cut out the low
frequency components of input voice signals.
t PTT LOCK INDICATOR [LOCK]
(Only for the SM-30)
Lights red when the PTT lock switch (w) is ON.
y MIC GAIN VOLUME [MIC GAIN]
Rotate to adjust the microphone output level.
• Use this control as an addition to the microphone gain
setting of the transceiver.
Rotating the control too far clockwise may result
in an output level that is too high and transmit
signal distortion.