Icom IC-7600 - Page 44

35
3
BASIC OPERATION
Band edge warning beep (Continued) D
To programming the band edge:
q Perform the steps q to t as shown above, then select
either “ON (User)” or “ON (User) & TX Limit” setting.
 •[BAND] appears above the function switch (F-5).
w Push [BAND] (F-5) to open the band edge screen.
e Push [Y] (F-1) or [Z] (F-2) to select the desired
band edge.
 •Push[Ω ≈] (F-3) to select the upper and lower band
edge frequency entry cell.
 •Push[INS] (MF6) to insert a new blank band edge line.
 •Holddown[DEL] (MF7) for 1 second to delete the
selected band edge line.
r Input the desired frequency with the keypad, then
push [F-INP•ENT].
 •Push[GENE •] to input decimal point (“.”) between the
MHzandkHzdigits.
 •Programeachchannelfromlefttorightandeach
frequency must be higher than the preceding
frequency.
 •Thefrequencythatisduplicated,oroutofanamateur
band, cannot be programmed.
 •
If you want to return the band edge frequencies to their
default (initial) value, hold down [DEF] (F-4) for 1 second.
 Thebandedgeinitializescreenappears,thenhold
down [OK] (F-5)for1secondtoinitializeallbandedge
frequency settings.
t Push [EXIT/SET] to exit the set mode.
NOTE: All frequency ranges are set to default. So
you should delete or change it to add the desired
band edge frequency.
Main dial
EXIT/SET
F-5
F-1 F-2 F-3 F-4
DEF
[INS][DEL]
Keypad
OK
/
BAND
• Band edge screen