Icom IC-7600

75
4
RECEIVE AND TRANSMIT
Waveform Color (Current) 217 241 247
Set the waveform color for the currently received
signals.
• The color is set in RGB format.
• Push [Ω ≈] (F-3) to select R (Red), G (Green) and
B (Blue), and rotate the main dial to adjust the ratio
from 0 to 255.
• The color is displayed in the box beside the RGB
scale.
Waveform Color (Line) 70 30 0
Set the waveform outline color for the currently
received signals.
• The color is set in RGB format.
• Push [Ω ≈] (F-3) to select R (Red), G (Green) and
B (Blue), and rotate the main dial to adjust the ratio
from 0 to 255.
• The color is displayed in the box beside the RGB
scale.
Waveform Color (Max Hold) 58 110 147
Set the waveform color for the received signals
maximum level.
• The color is set in RGB format.
• Push [Ω ≈] (F-3) to select R (Red), G (Green) and
B (Blue), and rotate the main dial to adjust the ratio
from 0 to 255.
• The color is displayed in the box beside the RGB
scale.
Waterfall Display ON
Turn the Waterfall display ON or OFF for the normal
scope or Mini scope screen. (In the wide screen,
the Waterfall is always displayed, regardless of this
setting.)
• OFF : Turns OFF the Waterfall display.
• ON : Turns ON the Waterfall display.
Waterfall Peak Color Level Grid 7
Select the signal level that the Waterfall displays a
peak color from Grid 1 to Grid 7.
Higher signal levels are Red, Yellow, Green, Light-
blue, Blue and Black in order.
Sweep Speed (± 2.5k) MID
Select the sweep speed for the ±2.5 kHz span
selection from SLOW, MID and FAST.
NOTE: Signals may be displayed incorrectly with
“FAST” setting.
Sweep Speed (± 5k) MID
Select the sweep speed for the ±5 kHz span
selection from SLOW, MID and FAST.
NOTE: Signals may be displayed incorrectly with
“FAST” setting.
Sweep Speed (± 10k) FAST
Select the sweep speed for the ±10 kHz span
selection from SLOW, MID and FAST.
Scope set mode (continued) D