N Skip channel/frequency setting
Memory channels can be set to be skipped during memory
skip scan. In addition, memory channels can be set to be
skipped during both memory skip scan and frequency skip
scan. This is useful to speed up the scan rate.
q Select a memory channel:
± Push [M/CALL] to select memory mode.
± Rotate [DIAL] to select the desired channel to be a skip
channel/frequency.
w Push and hold [S.MW](M/CALL) for 1 sec. to enter select
memory write mode.
e Push [∫](2) or [√](8) several times to select “SKIP.”
[DIAL]
Push or
several times.
r Rotate [DIAL] to select the skip condition from “SKIP,”
“PSKIP” or “OFF” for the selected channel.
• PSKIP : The channel is skipped during memory/bank scan and
the programmed frequency is skipped during VFO scan,
such as programmed scan.
• SKIP : The channel is skipped during memory or bank scan.
• OFF : The channel is scanned during any scan.
(Continue to the next page.)
108
10
SCAN OPERATION
To Next Page
Loading...
Need help?
General
