40
6
DV MODE PROGRAMMING
N
Repeater list programming
D New repeater list programming
q
Enter “ADD-L” in RPT-L menu.
MENU ¶ RPT-L ¶ ADD-L
(Push [MENU ]), (Push [](2)/[](8), then push [ ](5).)
• “R-NAME” appears.
Repeater name programming (R-NAME)
w Push [
](5) to enter the repeater name programming
state. See p. 44 for repeater name programming details.
• Repeater name programming screen is displayed.
e Program the repeater name, then push [ ](5) to exit the
state.
• Push [](2)/[](8) to select the desired character, number,
symbol or space.
• Push [](6)/[](4) to move the cursor right or left, respectively.
r Push [](2) or [](8) to select the next content (repeater
call sign programming).
Repeater call sign programming (CALL S)
t Push [
](5) to enter the repeater call sign programming
state. See p. 44 for repeater call sign programming de-
tails.
• Repeater call sign programming screen is displayed.
y Program the repeater call sign, then push [ ](5) to exit the
state.
• Push [](2)/[](8) to select the desired character, number,
symbol (‘/’only) or space.
• Push [](6)/[](4) to move the cursor right or left, respectively.
u Push [](2) or [](8) to select the next content (gateway
repeater call sign programming).
CONVENIENT!
After you program the repeater call sign, you can skip the
other programming and store the list.
± Push and hold [S.MW](M/CALL) for 1 sec. to enter mem-
ory write state, then push [
](5) to store the list.
To Next Page
Loading...
