45
6
DV MODE PROGRAMMING
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
Gateway repeater call sign programming (GW CALL)
q Push [ ](5) to enter the gateway repeater call sign pro-
gramming.
• Gateway repeater call sign programming screen is displayed.
• Programmed repeater call sign is displayed, then the 1st char-
acter blinks.
• The 8th digit is automatically added or replaced to “G.”
w Push [](2) or [](8) to select the desired character, num-
ber, symbol (‘/’ only) or space.
• The selected character blinks.
• Push [](6) to move the cursor right; push [](4) to move the
cursor left.
• Push [CLR](1) to erase the selected character, or push and hold
[CLR](1) for 1 sec. to erase all characters following the cursor.
e Repeat step w until the desired repeater call sign is pro-
grammed.
• Up to an 8 digit call sign can be set, but 8th digit must be set to “G.”
r Push [ ](5) to program the gateway repeater call sign and
exit the state.
N
Changing a repeater list
You can edit the contents of a repeater list to correct errors or
added information.
q
Enter “EDIT-L” in RPT-L menu.
MENU ¶ RPT-L ¶ EDIT-L
(Push [MENU ]), (Push [](2)/[](8), then push [ ](5).)
• Programmed repeater name appears.
SKIP indicator
SKIP indicator shows the selected repeater can not be used
as an access repeater (RPT1) in DR mode as follow reasons.
• “R1 USE” is set to “NO”
• Either “FREQ” (frequency) or “DUP” (duplex direction)
has not been programmed
Push and hold for 1 sec. to select SKIP indicator ON or
OFF when both of “FREQ” and “DUP” have been programmed.
w Push and hold [BAND] for 1 sec. to enter group selection,
rotate [DIAL] to select the desired group (0–9), then push
[BAND].
e Push [](2) or [](8) to select the desired repeater list to
be changed.
To Next Page
Loading...
