Icom IC-E80D - DTCS and Scan Configuration; DTCS Code (CODE) Setting; DTCS Polarity (DTCS-P) Setting; Digital Code (D CODE) Setting

112
11
PRIORITY WATCH
N Priority watch operation
D Memory/call channel and memory scan watch
q Select the VFO mode; then, set an operating frequency.
w Select the channel(s) to be watched.
For memory channel watch:
Select the desired memory channel.
For call channel watch:
Select the desired call channel.
For memory scan watch:
± Select memory mode, or the desired bank group.
± Push and hold [SCAN](V/MHz) for 1 sec. to enter the
scan type selection.
± Rotate [DIAL] to select the desired scan type, then push
[SCAN](V/MHz) again to start memory/bank scan.
e Enter “PRIO” in SCAN set mode.
MENU ¶ SCAN ¶ PRIO
(p. 121)
(Push [MENU ]), (Push [](2)/[](8), then push [ ](5).)
r Push [](2) or [](8) to select “ON.”
• Select “BELL” if the priority beep function is desired.
t Push [MENU ] to exit SCAN set mode and start the
watch.
• “PRIO” indicator appears.
• The transceiver checks the memory/bank channel(s) or call
channel every 5 sec.
• The watch resumes according to the selected scan resume con-
dition. (p. 110)
y Push [V/MHz] to cancel the watch.
Monitors VFO frequency
for 5 sec.
Pauses on a memory
or call channel when
a signal is received.
• During priority watch
Emits beep and blinks “S” indicator when a signal is
received on a memory or call channel.
• During priority watch with priority beep