Icom IC-E80D - Page 149

141
12
MENU SCREEN OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
 GPS-A symbol (SYMBOL)
Selects the desired GPS-A symbol.
Available symbols: AMBU (Ambulance), BUS (Bus), FIRE
(Fire Truck), BICYCL (Bicycle), YACHT (Yacht), HELI (Heli-
copter), AIRCRA (Small Aircraft), SHIP (Power Boat), CAR
(Car): (default), MCYCLE (Motorcycle), BALLOO (Balloon),
JEEP (Jeep), RV (Recreational Vehicle), TRUCK (Truck), VAN
(Van) and OTHER (Other).
If “OTHER” is selected, set the desired symbol code as fol-
lows;
q Push [
](5) to begin the programming.
w Push [](2) or [](8) to select the 1st character from “\”
and “/.”
e Push [](6) to select the 2nd digit.
r Push [](2) or [](8) to select the 2nd digit character.
t Push [
](5) to program the symbol code, then exit pro-
gramming.
y Push [](4) to return to GPS-A set mode screen.
When “OTHER” is selected, check the symbol codes of
APRS
®
and set it correctly.
Car is selectedHelicopter is selected
 Comment (COMMEN)
Program up to a 43-character* comment. The programmed
comment is transmitted with the GPS position data.
*Only 36 characters are available when “CUR/SPD”
(COURSE/SPEED) is selected in DT EXT (Data extension).
q Push [
](5) to enter the programming.
w Push [](2) or [](8) to select the desired character.
• The selected character blinks.
• Push [](6) to move the cursor right; push [](4) to move the
cursor left.
• Push [CLR](1) to erase the selected character, or push and hold
[CLR](1) for 1 sec. to erase all characters following the cursor.
e Repeat step w until the desired comment is programmed.
r Push [
](5) to program the comment and exit comment
programming.
t Push [
](4) to return to GPS-A set mode screen.