Icom IC-E80D - Cloning Functionality; Transceiver-to-Transceiver Cloning

149
13
OTHER FUNCTIONS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
D Setting UR and MY call signs for digital call
sign squelch or beep
q Push and hold [MODE](BAND) for 1 sec. several times to
select DV mode.
w Enter “UR” in CALL-S set mode.
MENU ¶ CALL-S ¶ UR
(p. 37)
(Push [MENU ]), (Push [](2)/[](8), then push [ ](5).)
e Push [](2) or [](8) to select the desired call sign.
• Input the call sign if the desired call sign is not stored in the
transceiver. See p. 37 for detail.
r Push [ ](5) to specify the call sign and then push [](4)
to return to CALL-S set mode.
• Push [

](4) to return to CALL-S set mode without storing call
sign.
t Push [](2) three times to select “MY” in CALL-S set
mode, then push [
](5) to enter “MY” setting.
MENU ¶ CALL-S ¶ MY
(p. 36)
(Push [MENU ]), (Push [](2)/[](8), then push [ ](5).)
y Push [](2) or [](8) to select the desired call sign.
• Input the call sign if the desired call sign has not stored in the
transceiver. See p. 36 for detail.
u Push [ ](5) to set call sign and push [MENU ] to re-
turn to the frequency screen.
IMPORTANT: Use digital code squelch when operating with
more than 3 stations. Because the digital call sign squelch
function recognizes “MY” (MY CALL SIGN) the digital call
sign squelch function can be used when operating with only
one station.
NOTE:
• The tone/DTCS code squelch opens sometimes when
other stations communicate with adjacent tone frequency
or DTCS code.
• In DV mode, if the IC-E80D does not receive “MY,” you will
not hear audio even though the S-meter is moving.