Programming IDEC SmartRelay
IDEC SmartRelay Manual 90
Closing the programming mode
Although you were shown how to exit the programming
mode when you created your first circuit program,
here is a reminder:
1. To return to the programming menu: Press ESC
2. To return to the main menu: Press ESC
3. To move the '>' cursor to 'Start': Press ▲ or ▼
4. To confirm 'Start': Press OK
IDEC SmartRelay is back in RUN mode:
2005-01-27
Mo 09:30
You can press or to scroll the pag-
es and to monitor the I/O states.
▲
▲
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com
To Next Page
Loading...