Programming IDEC SmartRelay
IDEC SmartRelay Manual 96
If you are sure that you want to delete the circuit program
from memory:
5. Move the ‘>’ cursor to ‘Yes’: Press ▲ or ▼
6. Press OK.
7. Enter your password.
8. Press OK. The circuit program is deleted.
Note
Although you may have forgotten your password, you can still de-
lete the circuit program by entering the wrong password three
times.
3.6.13 Summertime/wintertime conversion
You can enable or disable automatic summertime/wintertime
conversion
• in parameter assignment mode by calling the “Set..”
menu command
• in programming mode by calling the “Setup” menu com-
mand.
To enable/disable automatic S/W Time conversion in program-
ming mode:
1. Switch IDEC SmartRelay to programming mode.
2. You are now in the main menu and want to select the
‘Setup’ menu command: Press ▲ or ▼
3. Confirm ‘Setup’: Press OK
4. Move the ‘>’ cursor to ‘Clock’: Press ▲ or ▼
5. Confirm ‘Clock’: Press OK
6. Move the ‘>’ cursor to ‘S/W Time’: Press ▲ or ▼
7. Confirm ‘S/W Time’: Press OK
Password?
ZZ
To prevent unintentional deletion
of your circuit program, you are
prompted to enter your password
(provided you have assigned
one).
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com
To Next Page
Loading...
Need help?
General
